Press the tape down around the centre to make it water resistant.
Wet your the open part of your card using water and a large brush.
Start applying your watercolours, avoid mixing any colours that would make brown or green.
Dry the card thoroughly using a heat gun.
Remove any tape glue from your card with an adhesive eraser then pat an anti static pad over your card.
Heat emboss with clear embossing powder.
Return your card to the stamping platform and restamp your tree then clear heat emboss again, this will make your tree very raised and glossy.
Image Go to Words, stamp in black versafine at the bottom right hand side of your card and clear heat emboss as before.
Allow the card to cool for a few moments then wipe off any residual anti static powder with a soft cloth/paper towel.
Allow the card to cool for a few moments then wipe off any residual anti static powder with a soft cloth/paper towel.
Finally add a couple of black adhesive gems to the top right hand side.
I hope you have enjoyed this project and thanks for stopping by 💖,
Ali xxx
You can purchase these stamps and stencils here https://visibleimage.com/
Items used
- Visible Image Stamps - Tree of Life & Go To Words
- Arteza metallic watercolours, White Nights Watercolours
- Masking Tape for watercolours - Scotch or Sheena's
- Stamping Platform
- Anti Static pad
- Black Versafine ink pad
- Clear embossing powders
- Paint brushes
- Gold sparkle gel pen
- heat gun
- Watercolour card and black card for matting and layering
- 6" x 6" white card blank for second card
- pva
- black adhesive gems
Visible Image Links
No comments:
Post a Comment